Search results
Results from the Go Local Guru Content Network
1.1.1.1 was not a reserved IP address, yet was abused by many existing routers (mostly those sold by Cisco Systems) and companies for hosting login pages to private networks, exit pages or other purposes, rendering the proper routing of 1.1.1.1 impossible on those systems.
Binary Synchronous Communication ( BSC or Bisync) is an IBM character-oriented, half-duplex link protocol, announced in 1967 after the introduction of System/360. It replaced the synchronous transmit-receive (STR) protocol used with second generation computers. The intent was that common link management rules could be used with three different ...
In Internet networking, a private network is a computer network that uses a private address space of IP addresses. These addresses are commonly used for local area networks (LANs) in residential, office, and enterprise environments. Both the IPv4 and the IPv6 specifications define private IP address ranges.
If properly configured, the PC can also function as the router for a home LAN. An internal modem can be installed on a single PC (e.g. on a PCI card), also allowing that single PC to connect to a WAN. Again, the PC can be configured to function as a router for a home LAN. A cellular wireless access point can function in a similar fashion to a ...
v. t. e. An interior gateway protocol ( IGP) or Interior routing protocol is a type of routing protocol used for exchanging routing table information between gateways (commonly routers) within an autonomous system (for example, a system of corporate local area networks). [1] This routing information can then be used to route network-layer ...
A session border controller ( SBC) is a network element deployed to protect SIP based voice over Internet Protocol (VoIP) networks. Early deployments of SBCs were focused on the borders between two service provider networks in a peering environment. This role has now expanded to include significant deployments between a service provider's ...
The need for protocol standards can be shown by looking at what happened to the Binary Synchronous Communications (BSC) protocol invented by IBM. BSC is an early link-level protocol used to connect two separate nodes. It was originally not intended to be used in a multinode network, but doing so revealed several deficiencies of the protocol.
v. t. e. In telecommunications, long-term evolution ( LTE) is a standard for wireless broadband communication for mobile devices and data terminals, based on the GSM / EDGE and UMTS / HSPA standards. It improves on those standards' capacity and speed by using a different radio interface and core network improvements.